If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Before I glue down the underdash insulation and the black formed deadener, can someone tell me if I need to route or install something else first. I really don't want to rip this stuff up later to route something under it. For example, does the PW cable go under one or both sets of this material. Are the wires to the foot switch routed under the black stuff. Most of this will probably be self evident once I get into it, but if there are any nuances I'd appreciate knowing those.Thanks for any advice.
The upper dash insulation was glued to the back side of the plenum (photo below), and the heavy formed black dash mat below it on the vertical surface was installed with the push-in rubber fasteners.
The wool like material (similar to under the carpet) glued at the top area is typical more of a sound deadner (engine noise) where as the fiber type attached to the chip board and held on with rubber plugs is more for heat insulation. There shouldn't be much heat above the wiper motor area as there is around the bell housing and near the exhaust.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment