If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I am installing the brake line that runs from the right front caliper to the relay on the driver's side where all the front brake lines meet. I'm trying to be careful not to bend the line and am having a hard time getting it in. Do I need to take the radiator out to do this, or is there a way to twist it in around the radiator, frame, etc..
Bill, I got mine in with out(re)moving anything on a 68 327 car. I used bulk line and made my own so I was able to manipulate and bend it to fit once it was in its approximate location. Which would make things a bit harder if your concerned about not messing up a pre-bent line though should still go in with the same finesse. I used the old factory line to duplicate the new one.
Bill, I got mine in with out(re)moving anything on a 68 327 car. I used bulk line and made my own so I was able to manipulate and bend it to fit once it was in its approximate location. Which would make things a bit harder if your concerned about not messing up a pre-bent line though should still go in with the same finesse. I used the old factory line to duplicate the new one.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment