Q-Jet ID please. - NCRS Discussion Boards

Q-Jet ID please.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Greg L.
    Extremely Frequent Poster
    • March 1, 2006
    • 2291

    #16
    Thanks Clem *NM*

    Comment

    • Jack H.
      Extremely Frequent Poster
      • April 1, 1990
      • 9906

      #17
      Re: Q-Jet ID please.

      Rods should be embossed with ID marks (AK, AJ, Etc) that define the rod diameter, taper + tip profile. If memory serves, there's a nice lookup table in the HP Books issue on QJet carbs...

      Comment

      • Greg L.
        Extremely Frequent Poster
        • March 1, 2006
        • 2291

        #18
        Re: Q-Jet ID please.

        I have that book Jack and those markings that you refer to are what I was expecting to see....but they just ain't there...

        Comment

        Working...

        Debug Information

        Searching...Please wait.
        An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

        Please push the back button and reload the previous window.'
        An unexpected error was returned: 'Your submission could not be processed because the token has expired.

        Please push the back button and reload the previous window.'
        An internal error has occurred and the module cannot be displayed.
        There are no results that meet this criteria.
        Search Result for "|||"