If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
When I rebuilt my 4657 pump I took it to a carburetor rebuilder and had it tumbled and also had the two mating surfaces touched up on a belt sander to make sure they are flat. I think the kit came from Paragon and I can tell you the fuel pump pressure is 5 1/4 pounds at idle.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment