If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Pulling front main bearing on warner manual trans.
Pulling front main bearing on warner manual trans.
he front main bearing does not want to move. I made a longer regular puller out of 1/4" strap; but does not want to move. I want to proceed cautiosly, so thought I'd ask first.the factory manual shows a clamping puller arond the bearing. Is there another way; or how much, and where do I find a suitable puller?
Re: Pulling front main bearing on warner manual tr
Assuming the snap ring has been removed, you can get a tool that will cup the bearing in the area between the rear of the bearing and the gear teeth, and using that tool as the stationary surface, use a press from the pilot shaft and it will come right off. You can buy one inexpensively, or a parts store can generally rent you one.
Re: Pulling front main bearing on warner manual tr
Assuming the snap ring has been removed, you can get a tool that will cup the bearing in the area between the rear of the bearing and the gear teeth, and using that tool as the stationary surface, use a press from the pilot shaft and it will come right off. You can buy one inexpensively, or a parts store can generally rent you one.
Re: Pulling front main bearing on warner manual tr
If you pull the pin out of the cluster. it will drop down enough to clear the bearing diameter and you can push the bearing bach into the case by removing the locating ring. a better alternative if you still have it in the case, is just to pull off the snap ring and set the case and input as an assembly up in the press and push the shaft out that way. I'm assuming you ahve already pulled apart the case and tailhousing.
Re: Pulling front main bearing on warner manual tr
If you pull the pin out of the cluster. it will drop down enough to clear the bearing diameter and you can push the bearing bach into the case by removing the locating ring. a better alternative if you still have it in the case, is just to pull off the snap ring and set the case and input as an assembly up in the press and push the shaft out that way. I'm assuming you ahve already pulled apart the case and tailhousing.
Re: Pulling front main bearing on warner manual tr
Yes the tailhousing and front retainer are off. I was just getting ready to investigate just pushing the whole assembly through. The manual said you had to do it this way to clearance from the other gear and shaft assembly. However if I can pull the idler shaft, this might get the gears out of the way enough to push it through. Now watch the bearing will hang on the case next! my normal luck.
Re: Pulling front main bearing on warner manual tr
Yes the tailhousing and front retainer are off. I was just getting ready to investigate just pushing the whole assembly through. The manual said you had to do it this way to clearance from the other gear and shaft assembly. However if I can pull the idler shaft, this might get the gears out of the way enough to push it through. Now watch the bearing will hang on the case next! my normal luck.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment