56/7 soft top header thin metal plates

[TLSmith]

Does anyone have or know where I might find the two thin metal plates that attach to the front header, 1 per side, on the soft top?????

[Gary Fickeisen]

Re: 56/7 soft top header thin metal plates

TL:
I looked for a couple of years for a set of these. Finally found a pair at Carlisle.
I think I paid $60.00 from Country Corvettes. As far as I know only used are available.
Good luck.
Gary

[Gary Fickeisen]

Re: 56/7 soft top header thin metal plates

TL:
I looked for a couple of years for a set of these. Finally found a pair at Carlisle.
I think I paid $60.00 from Country Corvettes. As far as I know only used are available.
Good luck.
Gary

[John H.]

Re: 56/7 soft top header thin metal plates

TL -

You might try Sully's Tops (Jerry Sullivan), (800) 451-3998; they make reproduction Corvette top frames and sell individual parts.

[John H.]

Re: 56/7 soft top header thin metal plates

TL -

You might try Sully's Tops (Jerry Sullivan), (800) 451-3998; they make reproduction Corvette top frames and sell individual parts.

[TLSmith]

Any ideas as to function of these plates? *NM*

[TLSmith]

Any ideas as to function of these plates? *NM*

[James F.]

Re: Any ideas as to function of these plates?

Tom,
They flatten out the contour (slightly) at the end of the front header bar. Regards,

[James F.]

Re: Any ideas as to function of these plates?

Tom,
They flatten out the contour (slightly) at the end of the front header bar. Regards,