If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I am in the process of verifying numbers and codes on my 1967 convertible. Where can I find the frame number- I believe it is passenger side main frame rail toward the rear- but where- inboard, outboard, do I need to remove anything ?
It's on the driver's side frame rail. It's on the TOP surface of the frame rail APPROXIMATELY between the welded-on crossmember behind the differential crossmember and the #4 body mount. It is difficult to see inasmuch as the body is very close to the frame at this point. You will need to thoroughly clean the area with a small brush and then use a mirror to see it. Even then, it will be difficult. It was DESIGNED to be difficult to access.
Mike,
The frame is marked/stamped in 2 locations with the serial# on my 67.
The first location is under the drivers door about 12 inches ahead of the #3 body mount location (literally impossible to see with the body on). The second location is adjacent and just forward of the left side #4 body mount. As Joe said its a tight squeeze to see it. Good luck.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment