c2-radio hole cut out - NCRS Discussion Boards

c2-radio hole cut out

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Larry Boden

    c2-radio hole cut out

    Hello everyone, Just pulled the radio out of my 63 Z06 and found an irregular cut out. Looks as if someone drilled the corner and cut it out from there. Now the question is: if this hole was cut out by the factory was it done as tidy as the clock, vent knobs etc..? Upon initial investigation there was some confusion on whether the antenna had the correct ground straps for an AM only car. (Feb) or an AM/FM setup. Any thoughts would be appreciated. If this isn't a factory hole any restoration tips would be welcome. Larry Boden
  • Bob R.
    Extremely Frequent Poster
    • June 30, 2002
    • 1595

    #2
    Re: c2-radio hole cut out

    The car may have been a radio delete. The radio might have been installed later. My 63 has a sharp clean cut out. The dash surround is fibreglas covered with vinyl. The radio opening has a trim molding around it. I would think between the vinly covering and the trim bezel you could hide the damage.

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"