C1 RADIUS RODS - NCRS Discussion Boards

C1 RADIUS RODS

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Joe D.
    Expired
    • April 30, 2002
    • 382

    C1 RADIUS RODS

    I INSTALLED MY REAR ON MY 1961.I FIRST INSTALLED THE SPRINGS. WHEN I WENT TO INSTALL THE RADIUS RODS, THE RIGHT SIDE WENT ON FINE. THE LEFT ONE IS ABOUT ONE INCH FROM LINING UP. THE MOUNT ON THE REAR FOR THE LEFT SIDE IS NOT EVEN WITH THE RIGHT SIDE, IT IS BACK FURTHER ON THE HOUSONG. IS THIS NORMAL? THAKS, JOE
  • bob downs

    #2
    Re: C1 RADIUS RODS

    well, was it lined up when you took it off?? if so did the housing seat on the bolt head on the leaf springs? loosen up the "u" bolts that hold the housing to the springs and see if that helps. are the radius rods the same length? has the mount been welded on? the radius bracket on the right side is the one that takes a beating not the left. my guess is you need to loosen up the housing and everything will fit.

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"