67 oil pan drain plug - NCRS Discussion Boards

67 oil pan drain plug

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Charles H.
    Infrequent User
    • December 1, 1991
    • 1

    67 oil pan drain plug

    Fist time posting, so not to familar with the site.

    My '67 small block oil drain plug is stripped. Does somebody manufacture one with oversized threads or is there another remedy that members suggest (without buying a whole new pan).

    Thanks.
  • Joe L.
    Beyond Control Poster
    • February 1, 1988
    • 43193

    #2
    Re: 67 oil pan drain plug

    Originally posted by Charles Hunter (20280)
    Fist time posting, so not to familar with the site.

    My '67 small block oil drain plug is stripped. Does somebody manufacture one with oversized threads or is there another remedy that members suggest (without buying a whole new pan).

    Thanks.

    Charles-------


    There are a variety of ways to repair this problem which is fairly common. GM used to sell a replacement flange plate under GM #3723008 but it's now discontinued. However, this plate could be easily made using a piece of 5/16" thick flat steel stock and drilling and tapping it for 1/2"-20 thread size. The big problem here is removing the old plate which is spot welded to the inside of the pan.

    You might also be able to repair the threads by using a "Thread-Sert" which is available from sources like McMaster-Carr. I've never done this for an oil drain plug but I think it could work very well.

    There are also some "self-tapping" oversize drain plugs available. Most auto stores carry these. I don't like them too much, though.
    In Appreciation of John Hinckley

    Comment

    • Edward J.
      Extremely Frequent Poster
      • September 15, 2008
      • 6940

      #3
      Re: 67 oil pan drain plug

      Charles, There is truly no easy way to repair, the oversized drain plug is one way, But don't forget any metal that may get removed from jamming a over sized drain plug will be sitting on the bottom of the pan that may not work that great or for a long haul. The correct way is better to remove the pan and drill and install a Helicoil as Joe say's, then you'll be able to clean the bottom of the pan and any metal that is there from the install of the helicoil.
      New England chapter member, 63 Convert. 327/340- Chapter/Regional/national Top Flight, 72 coupe- chapter and regional Top Flight.

      Comment

      Working...

      Debug Information

      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"