What type of screws are used to attach the hood release pull, left and right fresh air vent pulls, rear exhaust fan pull and finally the steering column escutcheon (collar) to the underside of the dash? Are they all the same or are some fine thread machine screws? Thanks in advance. Jack J.
1964-65 coupe
Collapse
X
-
Re: 1964-65 coupe
Jack, hood release are 5/16 coarse thread recessed hex head screws with built on washer about 7/8 to 1inch long, fresh air vents are a oval head cad or zinc self tapping Phillips head about 3/4 inch,steering column where a fine thread black phos. flat head philips about 1 inch. I not sure about rear exhaust fan screws.What type of screws are used to attach the hood release pull, left and right fresh air vent pulls, rear exhaust fan pull and finally the steering column escutcheon (collar) to the underside of the dash? Are they all the same or are some fine thread machine screws? Thanks in advance. Jack J.New England chapter member, 63 Convert. 327/340- Chapter/Regional/national Top Flight, 72 coupe- chapter and regional Top Flight.- Top
Comment