62 headlight retainer rings

[John F.]

Should ther be two hold-down screws or three? I just purchased a new bucket from CC and there are two but ther new bulb retainer has three holes on them.

[John H.]

Re: 62 headlight retainer rings

Headlamps are normally attached to the bucket by two adjustable screws into plastic anchors (one for vertical adjustment, one for horizontal) and one spring.

[Mike E.]

Re: 62 headlight retainer rings

John's right on for 62's (and 61's and 60's and 59's and 58's and more)

[John F.]

Re: 62 headlight retainer rings

John, I'm talking about the stainless retaining rings that hold the headlamp in, not the adjusting screws for the the headlamp. The new stainless retaing rings have three hold-down slots for screws to go thru but there are only two receptacles. I got the retaing rings from CC.

[Michael H.]

Re: 62 headlight retainer rings

John, I'm talking about the stainless retaining rings that hold the headlamp in, not the adjusting screws for the the headlamp. The new stainless retaing rings have three hold-down slots for screws to go thru but there are only two receptacles. I got the retaing rings from CC.

The two tab stainless retaining ring was used from 58 through the end of the 63 model. Starting in 64, there were three tabs on the cup and the ring.