'67 Power Window conduit screws... - NCRS Discussion Boards

'67 Power Window conduit screws...

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Patrick T.
    Expired
    • September 30, 1999
    • 1286
    #1

    '67 Power Window conduit screws...

    If you have power windows, you will notice the tubular steel conduits which house the wires from the window motor that go to the wiring harness under the dash.

    The '67 Judging Manual states that these conduits shall be painted gloss black, no matter what the color of the car. What it doesn't mention is the color of the two screws which secure the conduit to the door. Are they zinc plated or should they be gloss black as well? Thanks, PT
    Tags: None
      • Top
    • Joseph T.
      Very Frequent User
      • March 1, 1986
      • 169
      #2
      Re: '67 Power Window conduit screws...

      Patrick,
      What I have observed on original and restored cars are Zinc plated, Hex head, shouldered screws without any paint.
        • Top

        Comment

        • Mike M.
          Director Region V
          • August 31, 1994
          • 1463
          #3
          Re: '67 Power Window conduit screws...

          The heads are recessed shouldered hex head with an achor headmark, similar to those on the body mount access plate inide the rear wheelwell.
          Attached Files
            • Top

            Comment

            • Gary J.
              Extremely Frequent Poster
              • April 1, 1980
              • 1229
              #4
              Re: '67 Power Window conduit screws...

              This is listed in the 1966 fourth edition judging manual.

              The conduit is painted gloss black and is secure with two 5/16 inch cadmium or zinc plated (or black phosphate) hex head screws wtih shoulder washers or black "Hi-Hat" hex head screws. Either type of fastener is considered correct.
                • Top

                Comment

                • Patrick T.
                  Expired
                  • September 30, 1999
                  • 1286
                  #5
                  Re: '67 Power Window conduit screws...

                  Thanks for the information guys. The screws I got from LICS are the same in the picture below and I'll use them. PT

                    • Top

                    Comment

                    • Mike M.
                      Director Region V
                      • August 31, 1994
                      • 1463
                      #6
                      Re: '67 Power Window conduit screws...

                      Right choice, Patrick.
                      The '66 JG revision references the zinczd finish only.
                      HaND
                        • Top

                        Comment

                        Previous template Next
                        Working...

                        Debug Information

                        Searching...Please wait.
                        An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

                        Please push the back button and reload the previous window.'
                        An unexpected error was returned: 'Your submission could not be processed because the token has expired.

                        Please push the back button and reload the previous window.'
                        An internal error has occurred and the module cannot be displayed.
                        There are no results that meet this criteria.
                        Search Result for "|||"