64 Turn Signal Switch - NCRS Discussion Boards

64 Turn Signal Switch

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Steve G.
    Expired
    • March 1, 1993
    • 43

    64 Turn Signal Switch

    I need to replace my turn signal switch can anyone tell me the best way to remove and install the switch ? Thanks
  • Jack H.
    Extremely Frequent Poster
    • April 1, 1990
    • 9906

    #2
    Re: 64 Turn Signal Switch

    Disconnect the 'harmonica' connector from the lower side of the steering column. Turn it sideways (to minimize width relative to the harness) and tape it to the harness so it can't move and/or catch.

    Now, attach a pull-string or wire to the bottom end of the harness. Remove the switch from the upper column and SLOWLY + CAREFULLY wiggle and pull the harness up and out of the column dragging the pull-string with it.

    Reverse the proceedure when installing your replacement switch/harness assy and use the pull-string to draw the harness down/through the interior of the column.

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"