Re: heater core tube crimp - OK to reuse?
Whew! OK then, good luck. I found that re-assembly was much easier than disassembly other than that one nut. Not trying to figure out where all of those hidden fasteners are at saves a lot of time.
I do recommend making a few trial runs placing the fan housing back over the core before coating the edges with sealant. It takes a few precise 3-D rotations to keep from smearing sealant over everything in sight. A couple of practice trys and it will go on easily and cleanly when it counts.
Whew! OK then, good luck. I found that re-assembly was much easier than disassembly other than that one nut. Not trying to figure out where all of those hidden fasteners are at saves a lot of time.
I do recommend making a few trial runs placing the fan housing back over the core before coating the edges with sealant. It takes a few precise 3-D rotations to keep from smearing sealant over everything in sight. A couple of practice trys and it will go on easily and cleanly when it counts.
Comment