still looking for a 55 bracket

[Roy B.]

Still looking for a 55 Corvette generator support bracket that goes Between the Gen & exshaust manifold 7 1/8 long having only two bolt holes (ONLY) NOT three that most dealers sell . First hole from the front is 1 3/8 and the next hole 5 1/8 or about that . I cant seem to locate a REAL bracket for a 55 Corvette, it must be a one off item. Any one know a dealer who would have one? The bottom pic is what it should look like but it's not the correct hole measurements .Thanks guys

[Mike M.]

Re: still looking for a 55 bracket

weld hole shut and re-drill.mike

[Roy B.]

Re: still looking for a 55 bracket

weld hole shut and re-drill.mike

Good thought I may have to, unless I could get you to give up one of the many you have

[Edward M.]

Re: still looking for a 55 bracket

Thought you found one on Ebay?

[Dan D.]

Re: still looking for a 55 bracket

Guys,

What is that third hole for? My 57 has three holes, thought that was an original part, but maybe not. -Dan-

[Roy B.]

Re: still looking for a 55 bracket

Thought you found one on Ebay?

That's what the seller said but wrong.

[Roy B.]

Re: still looking for a 55 bracket

Guys,

What is that third hole for? My 57 has three holes, thought that was an original part, but maybe not. -Dan-

I dont know but your's is correct for your exshaust manifold