3rd Arm Ball replacement? - NCRS Discussion Boards

3rd Arm Ball replacement?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Donald H.
    Extremely Frequent Poster
    • November 2, 2009
    • 2580

    3rd Arm Ball replacement?

    I was cleaning up my 3rd arm assembly and noticed some wear on one side of the ball (see picture). The ball measures 0.99 diameter on the unworn area and 0.96 diameter on the worn area.

    Does it need to be replaced?

    If yes, if you have done it, did you have to heat it before peaning or can I do it cold? I replaced the clutch cross shaft ball on the frame and pean it cold and it worked and seems solid.

    Thanks,

    Don
    Attached Files
    Don Harris
    Current: 67 convertible Marina Blue L79
    Former: 60 Red/Red, 2x4, 245hp (Regional and National Top Flight 2013), 66 coupe Nassau Blue, L79 (Chapter and Regional Top Flight 2017)
Working...

Debug Information

Searching...Please wait.
An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

Please push the back button and reload the previous window.'
An unexpected error was returned: 'Your submission could not be processed because the token has expired.

Please push the back button and reload the previous window.'
An internal error has occurred and the module cannot be displayed.
There are no results that meet this criteria.
Search Result for "|||"