If this is your first visit, be sure to check out the FAQ You must be an NCRS member before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below. If you have trouble logging in you can clear your cookies here!
On page B7 of section UPC 11-13 of the assembly manual, a measurement of 1.50 is noted by the rear edge of the front bumper. What does this measurement refer to?
On page B7 of section UPC 11-13 of the assembly manual, a measurement of 1.50 is noted by the rear edge of the front bumper. What does this measurement refer to?
Thank you,
Randy
Randy -
That's the clearance (looking straight down) between the tip of the bumper and the fender surface.
Thank you for the help. Fitting the bumpers has been quite an ordeal. I tried five different left side bumpers and found the measurements of all of them to be different.
C2 bumper measurement
Comment