Can someone advise me on refinishing my driveshaft with possible NCRS judging in mind.
THis is for a 60 with lots of old paint on the drive shaft. I can see some pitting and rust in some areas.
Per the TIM & JG the driveshaft was unpainted when installed and got blackout.
Since this was bascially a steel pipe it should have a smooth finish. If I blast it, it will not have an original looking surface. It would probably look better after spraying a clear coating.
I can blast it then paint it black, or clear coat it. Can anyone advise?
THis is for a 60 with lots of old paint on the drive shaft. I can see some pitting and rust in some areas.
Per the TIM & JG the driveshaft was unpainted when installed and got blackout.
Since this was bascially a steel pipe it should have a smooth finish. If I blast it, it will not have an original looking surface. It would probably look better after spraying a clear coating.
I can blast it then paint it black, or clear coat it. Can anyone advise?
Comment