K66 help

[Keith B.]

sort of off topic but I have a complete set up or I think I do for my 1966 SS 396 Chevelle. I have a original Amp box with a dead board. a wire harness, and a original dizzy. but in the AIM it shows a wire from the ignition switch to the T.I. harness. my T.I. harness on the dizzy end only has a 3 wire "T" with black, red, and gray connector, and the single white wire connector. does that sound correct. what goes to where? the AIM is a little fuzzy on this. thanks for any help.

[Bruce T.]

Re: K66 help

sort of off topic but I have a complete set up or I think I do for my 1966 SS 396 Chevelle. I have a original Amp box with a dead board. a wire harness, and a original dizzy. but in the AIM it shows a wire from the ignition switch to the T.I. harness. my T.I. harness on the dizzy end only has a 3 wire "T" with black, red, and gray connector, and the single white wire connector. does that sound correct. what goes to where? the AIM is a little fuzzy on this. thanks for any help.

Keith,

There are two schematics for the breakerless ignition system on page 6Y-15 of the 1966 Chassis Service Manual. One of these should be appropriate, but the only 3 wire connector shown has gray, white, and pink wires. The distributor shows white and white/green wires.

TI ignition 001.jpg