Assembly Manual unreadable data

[Scott M.]

In my 1972 Assembly Manual, I am looking at UPC 9, Sheet A4. The #3 torque value in the bottom left corner is unreadable due to a bad copy of the manual. Can anyone look it up in theirs and tell me what the value is? I can only make out the "100"

Thanks
Scott

[Alan S.]

Re: Assembly Manual unreadable data

Hi Scott,
It appears that's the value for the steering column bracket assembly nuts. 100-140 lbs. in. (note! inches not feet)
Regards,
Alan

[Don L.]

Re: Assembly Manual unreadable data

Scott, mine is of poor quality as well, however, I can make out "100-140 LBS". Whether it's "FT" or "IN" afterwards, I can't see due to poor copy quality. Gotta be "IN" though, looking @ the value and the application.

Hope this helps....

[Scott M.]

Re: Assembly Manual unreadable data

Alright Guys! I couldn't make out the 140 and definitely couldn't see the "IN" for inches! Although I did think foot pounds was a a little overdoing it.

Thanks
Scott

[Don L.]

Re: Assembly Manual unreadable data

Sorry for the double answer. Looks like Alan and I were searching and typing at the same time.