67 BB schroud ID... could I have 68 support or schroud?

[Domenic T.]

In 1971 I converted my 67/435 to A/C at the chevy dealership when I was working there.
Now that I am finishing a frame up resto I noticed that the passenger side of the schroud has 2 oblong mounting holes that are on 6" centers and what looks to be missing a place where another hole could be for a 8" center.
The drivers side is on 8" centers and the support is 8" centers, both sides along with the condencer.
I remember the parts manager saying something about a 68 part fitting when I got all my parts and it seems unlikely the shroud would have 3 mounting holes on the passenger side.
Was the 68 schroud 8" on drivers side and 6" mounting on the passenger side or were there 3 mounting holes on the passenger side on the 67?

My schroud was damaged years ago and might have broken off the top hole that would have been on 8" centers.

I plan on buying a schroud but wanted to see if infact I have a 67 schroud?


DOM

[Wayne W.]

Re: 67 BB schroud ID... could I have 68 support or schroud?

If the shroud was changed when the work was done, it is likely the 68 style which has the angle cut off of the RH side. Does it have that cut?

[Domenic T.]

Re: 67 BB schroud ID... could I have 68 support or schroud?

Wayne,
It looks like something was done on the upper right and I put a large washer on to hold it. The cut would have been where the upper bolt went.
My upper right just meets the hole in the support and is to short to make a hole.
As it is the left side has 2 holes 8" apart and fits great. The right has 2 holes and only the bottom hole lines up and the top hole is 2" shy of fitting.

DOM