If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Does anyone know the correct configuration for the undercar exhaust clamps (center cross-member, connect to the mid-support by the transmission mount) for a '66 L79 2 1/2 exhaust? The ones I have seen from LICS or Paragon do not purport to be correct and have a fully round u-shaped upper part of the clamp. I have also seen some where the u-shaped upper part is flattened where it goes over the center support (and then rounded where the threads are). The bottom part (connected to the upper part by the nuts) appears to be the same for both. Thanks.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment