T-10 seals

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Mike Przano

    #1

    T-10 seals

    Can anyone recommend a supplier for a seal kit. Most I've checked with want to sell me the entire rebuild kit and all I have is a front seal leak. Thanks in advance.
    Mike
  • Karl #35089

    #2
    Re: T-10 seals

    For just a seal, try your local auto parts store... Other than that, I can recommend Larry Fischer at D&L Transmission for any T-10 parts (or muncie for that matter). See website below:

    -Karl




    D and L Transmission dot com

    Comment

    • John Hinckley (29964)
      Beyond Control Poster
      • December 1, 1997
      • 16513

      #3
      Re: T-10 seals

      Mike -

      There is no front seal on a T-10 (or a Muncie); just the gasket between the bearing retainer and the main case. The only "seals" are O-rings on the shifter shafts in the side cover, the O-ring on the speedo gear sleeve, and the output shaft seal for the yoke.

      Comment

      • Mike McCagh (14)
        NCRS Past President
        • June 1, 1974
        • 8288

        #4
        Re: T-10 seals

        if you're referring to the early t-10s(57 to 63) and not the super t-10s (which i'm totally unfamiliar with), then i don't think you will find ANY seals in the front of the tranny. the only true seal is pressed into the tailhousing and a leak there shows up there. if you have a leak up front, it could be the throw-out bearing retainer gasket , but most commonly the front leak is due to leakage betweem the cluster gear shaft and the t-10 case,which isn't an easy fix. if all you need is the retainer gasket, chevy ought to have one.if you're not in a hurry, send me your address and i'll send you one on the house. mike

        Comment

        • Mike Przano

          #5
          Re: T-10 seals

          Thanks everyone for your response. If in fact it is the front gasket it sounds a little easier to replace than a seal. Haven't pulled the tranny yet so hopefully that's all it is.
          thanks again!
          Mike

          Comment

          • Karl #35089

            #6
            Re: T-10 seals

            Hi John: Next time I should read closer... skipped right over that little "front" word in the original post. You are of course correct. -k

            Comment

            • Mike Przano

              #7
              Re: T-10 seals

              Mike, unable to send you my address through the discussion board for some unknown reason. Please send me an email and I will reply with my address.
              Thanks!

              Comment

              Working...
              Searching...Please wait.
              An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

              Please push the back button and reload the previous window.'
              An unexpected error was returned: 'Your submission could not be processed because the token has expired.

              Please push the back button and reload the previous window.'
              An internal error has occurred and the module cannot be displayed.
              There are no results that meet this criteria.
              Search Result for "|||"