If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
i went to install a deck-lid w/s on the 69 ,GM part#3826967 and found the length a tad long, is the w/s to be spliced , and if so where ? and was this found on original or just on the replacement w/s, .
While door WS was 'cut' at the bottom center to promote outgassing and allow smooth close/latch action of the doors, the convertible deck lid WS was NOT cut. All of the circumference is exposed to ambient elements (wind/water) that can invade the rear compartment.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment