If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I was thinking about putting a new label on my a/c compressor when it is painted but the reproductions do not have date codes on them. Is there a way to stamp this code on it?
Ian - I've known folks to type them in using the manual typewriter. Another option, if you want to maintain the originality is to carefully mask off the label and paint the compressor. The foil label is a bit tricky so try not to stick the tape too hard on to the label. Pete
I used 1/8" tall stamps. I made a straight edge fixture from a combination square to rest the punches against so the numbers would be even. Wouldn't pass NCRS but better than blank. Buy 2 foil labels, one to practice on.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment