If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Ordered a new set of windshield washer nozzles for my 67. I noticed that the old ones have a (brass?) squirter "ball" that can be rotated by sticking a pin in it to adjust where they spray. The new ones I got from LI Corvette have a round brass squirter "face". It doesn't look like it can be adjusted or if so not adjusted easily.
What is the correct configuration for the windshield washer nozzles for a 67? Thanks!
if you are going to PV the vette, you'll have to use the originals as the repo's are near impossible to adjust and the judges will deduct on originality during flight judging as well.mike
Brian Tilles (Corvette Specialties of Maryland) had the first couple of sets of prototype reproduction midyear nozzles on display at Windsor and at Carlisle - they're spot-on; he can probably tell you when he'll have them available in volume.
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment