C2 '67 door panel removal

[Tom Merkel]

I need to remove the '67 vert door panels for a couple of reasons.

Yesterday, it became clear that there is a technique and/or a special tool required to get both window cranks and the lock button off.

These panels are original and in perfect condition, so I don't want to get too Bubba-like and screw them up.

Advice and input appreciated.

Thanks.

Tom

[Mike M.]

Re: C2 '67 door panel removal

most NAPA-type stores will sell you a tool to remove the horseshoe clip that retains the handles to the splined shafts of the regulators. since your door panels are original and mint, i'd take the tool to a local junkyard and practice on handle removal before going after your car's handles. mike

[Jack H.]

Re: C2 '67 door panel removal

In addition to the special tool designed for the job of pushing the horseshoe clip off the crank shaft, some of us prefer to use an L-shaped pick. You simply push the door panel back against the door to gain a modest bit of clearance so you can look with a flashlight behind the handle, see where the clip is and use the L-pick as a probe to grab and pull the C-clip free from the crank shaft...

[John H.]

Re: C2 '67 door panel removal

I made a U-shaped shim out of the smooth plastic lid for a coffee can to use between the handle removal tool and the surface of the trim panel so you can slide the tool into position without scraping the trim panel surface.

[Gary B.]

L-shaped pick

Tom,

John's L-shaped pick can easily be made from a large paper clip. I think this is the only safe way to remove the lock knob. I previously tried using the special tool from LIC, but it was never going to work without damaging my door panel.

Gary

[Dale S.]

Re: L-shaped pick

K-D tool make's one. It works great and no damage. I would use the idea if the coffee can lid if I need to again(door panels used to be not that expensive).

[Philip C.]

Re: C2 '67 door panel removal NO TOOLS

Hi Tom I use a clean rag, I thread it under the crank handle and with a circular motion you snag the clip and it pops right off. (takes a little practice). Then take some blue painters tape and tape off the doors above the panels, use a couple of layers, as you pull up on the panels they rub against the doors. Hope this helps Phil 8063

[Tom Merkel]

Thanks to all for good tips and info!!

Thanks, gentlemen. Those tips and info were exactly what I needed.

Tom