If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
Every spring when I grease the chassis on my two C-1's, I also get the U-joints on the driveshaft. The front one is a hassle to get at because of the X-frame.
How do the rest of you grease that one? There has to be a better way than the way I am doing it.
various zirk fitting adaptors are available to insert between the fitting and the grease gun. without knowing the style of zirk in your u-joint, its difficult to advise style adaptor you need. if you are only putting a couple thousand miles a year on the vette, greasing it every 10 to 15 years is probably adequate.mike
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment