Transmission video

[Mike N.]

Can anyone tell me where I can purchase the "ROY BRAATZ" video on how to rebuild a CAST IRON POWERGLIDE??

OR any other video will do as well-

Thank you in advance
Mike

[Jean C.]

Re: Transmission video

How about contacting Roy? He posts on this forum quite frequently and in fact he'll likely reply to your query.
Charlie

[Roy B.]

Re: Transmission video

My Brother in Law has them "Dan"
What's wrong with your's?

http://www.glassmandan.com/

[Mike N.]

Re: Transmission video

Hi Dan,

Can you write to my email address: Pats57@adelphia.net
with the information so I can purchase a video.

I need to exchange the TAILSHAFT W/OUTPUT SHAFT on my 1957 powerglide. I now have a 1960 "tail shaft" ( too short ) and need to get the trans. back to original.

I don't even know where to start. Good thing the body is off the frame. I plan on dismantling it while on the frame. Any suggestions greatly appreciated.

Thanks,
Mike

[Roy B.]

Re: Transmission video

Mike
I'm not "Dan" he's my brother in law, he has the Video I made, I looked at your trans pic. The Corvette tail housing having the three bosses can be changed easily in the frame. Do you have the right drive shaft?? Or heavy rear springs ?? The in-put flange sure is back from the trans quite a bit. And where you have the shifter mounted is off.