If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You must be an NCRS member
before you can post: click the Join NCRS link above to join. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm finishing installing the spark plug heat shields/ignition shields back on my '72 LT-1. I've got the AIM, but I'm still a little confused on exactly how everything goes together("V" shields, inner and outer shields). Is there another source that someone can recommend with diagrams or photos of these? I found some information in the archives here, but I just want to be sure. Only want to do this job once!
Thanks,
Steve
1978 L82/4spd Silver Anniversary: NCRS Top Flight; Bloomington Gold Survivor / Gold / Benchmark
1994 ZR1 Green / Beige
2009 Cyber Gray / Red Coupe
use a paragon or ?? catalog compare bothe should be able to figure it out---i think lt1 only used 5&7 6&8 plug sheilds only---some one out there will add more info
We use cookies to deliver our services, and to analyze site activity. We do not share or sell any personal information about our users. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment