Tweet
I have a 67 bb w/ac and a friend of mine disassembled the car when I got it so I could start to restore it. During the process I went to place the drivers side horn onto the radiator support and realized the horn did not fit. The condensor is an original GM sealed in a box dated 1969 and the radiator support is a replacement by coffman corvette. The bracket on the drivers side comes down above the middle of the bolt hole and the horn will not mount vertically. I did not remove it so I was wondering if anyone had a picture they could share with me.
-
-
Re: 67 Big Block w/AC drivers side horn mounting
Look at the face of the inner fender. There should be a bracket riveted there. -
Re: 67 Big Block w/AC drivers side horn mounting
That is on the passengers sideComment
-
Re: 67 Big Block w/AC drivers side horn mounting
Joe,
I have a 66 small block with same issue. I have always assumed my condenser was incorrect (too wide)as it partially covered the mounting hole.I have seen others with a narrower condenser where the horn fits vertically. I ended up using the lower mounting hole on the condenser
RandyComment
-
Re: 67 Big Block w/AC drivers side horn mounting
Joe,
Check this out. many others in archives
RandyComment
-
Re: 67 Big Block w/AC drivers side horn mounting
Thank youComment
-
Re: 67 Big Block w/AC drivers side horn mounting
OOPs, Sorry I didnt read that very well.Comment
Comment