1967 Bell Housing to Block Bolts - NCRS Discussion Boards

1967 Bell Housing to Block Bolts

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Jimmy G.
    Very Frequent User
    • November 1, 1979
    • 975

    1967 Bell Housing to Block Bolts

    Are these acceptable??

    "M" Grade 5

    Bell Housing Bolts.jpg
    Founder - Carolinas Chapter NCRS
  • Joe L.
    Beyond Control Poster
    • February 1, 1988
    • 43193

    #2
    Re: 1967 Bell Housing to Block Bolts

    Originally posted by Jimmy Gregg (2756)
    Are these acceptable??

    "M" Grade 5

    [ATTACH=CONFIG]106246[/ATTACH]

    Jimmy------


    My opinion is absolutely yes. In fact, I believe that non-trimmed ("indented") head, GM 280M (SAE 5), "M" headmark (Michigan Screw and Bolt), and zinc plated is, by far, the most common although other manufacturers' headmarkings were also likely used.

    I can't tell from the photo if the length is correct but I expect it is.
    In Appreciation of John Hinckley

    Comment

    Working...

    Debug Information

    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"