Missing something here, ground lugs and where they're supposed to go are not reaching

[Brandon T.]

I know I have the right length wires on the right cylinder, no question there.

on the passenger side I have cylinder wire lugs for cylinder 2 & 4 on the first valve cover bolt from the front and it reaches but is tight.

I have cylidner wire ground lugs for cylinder 6 & 8 on the 3rd bolt and they look fine.

........

on the driver side, cylinder wire ground lugs for cylinder 1 & 3 the #3 cylinder wire won't reach the first valve cover bolt from the front so I put them under the 2nd valve cover bolt from the front is this correct???????

then I put cylinder wire ground lugs for cylinder 5 & 7 under the rear/last valve cover bolt..


is this correct or no the aim is a hunk of junk on this one and I see pictures that vary from car to car..what is correct?

this is on my 68 l36, thanks

[Jack C.]

Re: Missing something here, ground lugs and where they're supposed to go are not reac

Brandon, the gounds don't go on the first v/c bolt, it's the second and forth on the drivers side.

[Brandon T.]

Re: Missing something here, ground lugs and where they're supposed to go are not reac

Brandon, the gounds don't go on the first v/c bolt, it's the second and forth on the drivers side.

Great! I was one T person when I thought the wires were bad repros!

here she is, thanks for the help so nice to have things done right with the help of the forum.

[Edward J.]

Re: Missing something here, ground lugs and where they're supposed to go are not reac

Brandon, everything looks neat and in place nice job. the hours spent on the engine and compartment shows.