C1 Front Crossmember to Frame Bolt Torque spec

[John L.]

What is the correct torque specification for the 16 bolts/nuts that attach the front crossmember to the frame on a 1954? Also is there a specification for the 4 bolts that attach the front thrid arm bracket. Did not want to strip any threads in the cast piece....
Thanks
John Lanning

[Gary C.]

Re: C1 Front Crossmember to Frame Bolt Torque spec

John,

Didn't see any torque specs in the ST12. The bolts are 3/8 inch Grade 2. You might check for torque specs on a Grade 2 bolt/nut.

Might send Tom Parsons an email.

Gary
....

[Dennis C.]

Re: C1 Front Crossmember to Frame Bolt Torque spec

John,

I can't speak about a 1954, but the 1961 AIM indicates 15 - 20 lbs ft for the crossmember bolts.

Dennis

[John L.]

Re: C1 Front Crossmember to Frame Bolt Torque spec

thank you for the information ..... was able to find most of the remaining torques on the front end but this was the one I could not find. Now i can finsih this Up...
Much appreciated!!!