461 heads with no end markings - NCRS Discussion Boards

461 heads with no end markings

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Duke W.
    Beyond Control Poster
    • January 1, 1993
    • 15610

    #16
    Re: 461 heads with no end markings

    Ah, yes. I was talking to someone recently about Brzezinki's work.

    Duke

    Comment

    • Loren L.
      Extremely Frequent Poster
      • April 30, 1976
      • 4104

      #17
      Re: 461 heads with no end markings

      Originally posted by Mike McCagh (14)
      Tom: after removing the camel's humps, take a needle air hammer(like the navy uses to de-rust their ships) and beat the hell out of the casting area where the humps have gone bye-bye. the air hammer will give the surface a rough, sand cast finish. i assume JB Weld or a similar epoxy was used to create the triangle on the top of the rectangle.one can also remove the 6 motor mount bosses on the side of the block to simulate a 348 block. the boos to attach the Z-bar pivot will also need to leave. all of the above is second hand info. regards,mike
      Butter does NOT melt in the good doctor's mouth............

      Comment

      Working...

      Debug Information

      Searching...Please wait.
      An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

      Please push the back button and reload the previous window.'
      An unexpected error was returned: 'Your submission could not be processed because the token has expired.

      Please push the back button and reload the previous window.'
      An internal error has occurred and the module cannot be displayed.
      There are no results that meet this criteria.
      Search Result for "|||"